- Above the surface: Drill the PowerHead into position so that the entire head sits on the surface of your material.
with surface: in combination with an impact driver, the PowerHead Screw
has been engineered with nibs underneath the head of the PowerHead that
cut through your material, allowing your screw to be perfectly flush
with the material surface
- Cap it! Install a 9/16
PowerHead cabinet installation screws give you options. In
combination with an impact driver drill, the PowerHead Screw has been
engineered with nibs to cut through your material, allowing your screw
to be perfectly flush with the surface.
Nominal or Screw Diameter: #8 gauge; 0.140
Threads per inch: 9
Thread diameter: 0.185 / 0.190
Shank diameter: 0.137 / 0.140
Length: 1 1/2"
Minimum Torque lbs./inch: 28 lbs./inch
Finish: Zinc plated
Head size: 9/16"
Head type: #2 square
Provides better engagement and reduction of bit "cam-out" while driving
Point: Type 17 Auger Point
Type 17 (21-23 point) allows screw to be driven into most woods without a
pilot hole. Wide threads provide greater holding power. Less torque
required to drive.